Motogadget MO.Button Relay

Motogadget MO.Button Relay

Motogadget has innovated with this mini relay that works in conjunction with the Mo.unit basic (MG14002035) or Blue (MG14002040). It allows you to connect the buttons of the switches (start, horn, turn signals, low/high beam lights, front brake switch) to the Mo.unit with a single wire (multiplexing type).

You will find it easy to conceal your electrical installation from your handlebars as only one wire runs from the handlebars to the MO.UNIT. Additionally, its minimalist size (diameter 12 mm, length 25 mm) allows you to place it inside your handlebars to eliminate visible cables.

Example of use:

a) Normally, the operating current (for example, the headlights or turn signals) is transmitted directly through the button wiring. Due to high currents, large gauge wires must be routed from the fuse box to the switch and back to the electrical consumer.
The result: bulky wiring harnesses. Definitely, with the MO.button, a simple wiring solution for customized motorcycles with limited space or concealed electrical systems.

b) By using the MO.UNIT basic or Blue with the MO.BUTTON, you only need to route one wire from the MO.BUTTON for each function controlled by a switch or button to the MO.UNIT. These wires only carry minimal control currents. All loads and high currents are switched directly on the mo.unit and transmitted directly to the electrical consumers. This already leads to a significant reduction and simplification of the motorcycle wiring harness.

c) By using the mo.unit Blue or basic in combination with the MO.button, you further reduce the number of wires to be routed! All switches/buttons on the handlebars are connected at a very short distance and concealed inside the handlebars. Therefore, you will only need to route ONE single wire from the MO.button to the mo.unit. All loads and currents will be switched directly on the mo.unit. A maximally reduced installation!

The MO.button is fully molded, making it waterproof and resistant to vibrations.

- Diameter: 12 mm
- Length: 25 mm
- Cable length: approx. 60 cm
- Connection cable to the mo unit: approx. 200 cm
- Weight: approx. 30 g
- Warranty: 2 years

Quality 'made in Germany' - by Motogadget.